3d printed handle

[MorrisonP]

Hey all!

I plan to 3d Print a brush handle from a carbon fibre impregnated filament, I have a few questions though!

1. does anything special need to be done to where the knot is glued in to ensure it stays? or is 2 part epoxy good to go?

2. What type and where can I get a good 'all around' brush knot without breaking the bank?
****I also need it to be in Canada so i can get it in time!****


3. any suggestions for shape since the 3d printer can pull off some more complex stuff than a lathe or other more traditional methods!

thanks everyone

[VictoriaSanderson]

how can I make a part on a 3D printer?

[Avanice]

I hear this questions quite often. Contact the repair service. Or contact the store where you bought the printer for help. I also had the same questions with my printer. Only I was stupid and didn't contact the repair service. I wanted to sort out in it myself. In finally I broke it. And I was without a printer for three years. Only just four months ago I decided to buy a printer at https://www.mrdepot.ca/collections/brot ... cartridges. Therefore, contact the repair service. To avoid being left without a printer.

[weber44]

thanks for the information

[JoanneCameron]

I hear this questions quite often. Contact the repair service. Or contact the store where you bought the printer for help. I also had the same questions with my printer. Only I was stupid and didn't contact the repair service. I wanted to sort out in it myself. In finally I broke it. And I was without a printer for three years. Only just four months ago I decided to buy a printer at https://www.mrdepot.ca/collections/brot ... cartridges. Therefore, contact the repair service. To avoid being left without a printer.

My friend was just looking for this information. Thanks

[elogbolog]

how can I make a part on a 3D printer?

[Jake_plein]

wow the 3d print pen is something. breakthrough and progress. I will buy it for sure